cable end
英 [ˈkeɪbl end]
美 [ˈkeɪbl end]
网络 电缆终端; 电缆连接
双语例句
- Again, you'll have to do some cable splicing and soldering, but in the end you avoid having to use an additional wall outlet.
同样，也需要焊接一点儿电路，但是这样最后就不需要使用另外一个墙上的插座了。 - Using the Ethernet cable supplied, connect one end of the cable to the Ethernet port on the EVM and the other end to your PC.
使用网线插入EVM上的以太网端口，另一端连接到您的PC网口一端连接。 - As there typically will be some cable slack at this end, cable tie after plugging in, then tape this down if someone could trip over the mic cable.
这里就是线缆的另一端了，如果会有人在此被绊倒，那么再用胶带把这些线贴到地板上。 - A Study on the Design Method of the Clamping Bolts on the Cable End of Motor Vehicle Winch
汽车绞盘钢丝绳端紧固螺栓设计方法的探讨 - The casing pipe is mainly used to solve present technical problems, such as complicated technical process for cable end sealing.
它主要是解决现有缆线端头密封的工序复杂等技术问题。 - Connect the temperature control cable core end to the temperature control lever on the back of the heater-A/ C control.
在取暖器-空调控制后部上连接温度控制电缆核末端至温度控制连杆。 - After locating this fault, the circuit identifies the open wire and allows you to open and repair the correct cable end.
定位这个故障后，电路识别开路电线，允许断开和修复正常的电缆端。 - Tyco Thermal Controls can provide a complete system from electrical transformer and heat-trace panel to power connections, heating cable, end terminations, glass tape and warning labels.
泰科热控提供一整套完备的系统，从配电变压器、电伴热控制柜到接线盒、伴热线、尾端、玻璃胶带和警示标签。 - The FPC cable end to which the USB connector board attaches is routed into the battery compartment and sits above the battery.
FPC电缆结束到哪一个万用串列总线联编者董事会附上进入电池安装区之内被溃败而且在电池上面坐。 - In general, earth the cable shield only at the control panel end.
通常接地电缆套管只在控制板末端使用。 - During the installation of ribbon heater, when one end of cable was connected to power, another end of bus bar should be sealed with matching head so that two bus bars will not have a short circuit.
电热带安装时，当电缆一端接入电源前应将母线另一端用配套的封头套封好，两条母线不得短路。 - Minor corrections can be made on the cable end piece.
可以在拉线端件进行一些较小的修正。 - By using the iterative solution, it is simple to determine the relation among the coordinate difference of cable end position, cable tension and cable weight.
利用迭代解可顺利地确定索端位置坐标差、索力及索重之间的关系。 - From test, the relationship of cable free end, anchor pier, foundation deformation and cable creep with load is revealed and rational design force for anchorage cable is proved.
通过试验，掌握了锚索自由端、锚墩和基础变形以及锚索徐变度与荷载的关系，验证了锚索设计吨位的合理性。 - EMP coupling must through cable ( aerial) coupling, the end conversion is an/ pulse current voltage to pass the cable to the integrated circuit, I/ O orifice results in the impact.
EMP耦合主要经过电缆（天线）耦合，最终转化为脉冲电流电压通过电缆对集成电路的I/O口造成影响。 - Multi-Function Cable DTV Front-end System
多功能有线数字电视前端系统 - The hybrid nonlinear distributed parameter system described a cable with one end fixed and with a mass attached at the other end. The mass was suspended by a spring, which had nonlinear stiffening terms and was forced by a disturbance.
该混合非线性分布参数系统描述一端固定，另一端粘附有质量块的振动电缆系统，该质量块由一弹簧悬挂着，且受外力扰动。 - With ASICs and application software, a digital cable receiving front end is designed and realized.
在专用硬件和应用软件的配合下，实现了一个数字有线接收前端系统。 - Construction of Cable Digital TV Head-end
有线数字电视前端的组建 - Finally, the design of the cable at the end of the deck is developed.
最后，推导了用于设计端锚索的解析式。 - The problems used to arise during pressurizing operation and its preparation work of the connection between the twisted aluminum steel core cable and the dead end clamp were described.
介绍了钢心铝绞线耐张线夹液压连接中，在施压准备工作和施压操作中容易出现的问题。 - The smart FRP-OFBG bars are placed into the parallel wire stay cable with each end bonded by epoxy resin grouts in anchors, and a new type smart parallel wire stay cable can be obtained.
拉索制作过程中，将FRP-OFBG筋布设到平行钢丝拉索中，并利用冷铸锚锚杯内的环氧砂浆固定FRP筋的两端，得到一种新型平行钢丝智能拉索。 - Process Technology of Cable End
电缆终端处理技术 - The inner linkage of cable was stored by end linkage in file or database form.
端口连接以文件或数据库形式存储电缆内部连接。 - You can not only use the cable of pier which is at the end and ancillary changes to reduce the pressure of the cable weight. By calculating the influences of the live load, we come to a conclusion of the internal force state of the cable-stayed bridge.
并且无法仅仅利用尾索与辅助墩处的拉索变化来减小压重。 - Based on numerical analysis, prestressed concrete technology scheme design is finished including prestress loss and prestress cable quantity estimation, prestressed cable position choice, cable shape and stretching end anchorage location design.
在对车站结构反复试算的基础上，完成预应力损失和预应力筋量的估算、预应力筋布索部位选择、索形以及张拉端锚固端定位设计。 - According to the elastic catenary theory, the spatial catenary cable element used for finite element analysis of the structure is derived from the exact analytical expression. The precise expression of two-node cable element tangent stiffness matrix and the tension of cable end are educed.
根据弹性悬链线的理论解析解推导出适用于导线结构有限元分析的空间悬链线单元，得到了两节点索单元的切线刚度矩阵和索端张力的精确表达式。 - The adjustment technics and effect of the strain of anchorage cable of Sidu River Suspension Bridge are illustrated in this paper, and the change of the strain of anchorage cable is analyzed in the end of the hoisting steel trussed girder of construction.
阐述了四渡河大桥锚跨张力调整的工艺和效果，分析了后期钢桁加劲梁吊装施工过程中索股锚跨张力变化。 - Through the simulation platform of MATLAB, the paper establishes the power cable fault system simulation model and obtains the cable faults fluctuations in the end.
通过MATLAB仿真平台，建立了电力电缆故障系统的仿真模型，得出电缆故障波形图。 - The external load is exerted on the end point of the robot by way of the cable pulley system and the displacement of the end point is measured via the API laser tracker.
通过滑轮加载装置在机器人末端施加外载荷，并使用激光跟踪仪测量机器人末端位移。